Roof Razor
With a dead-load capacity of 205kg between legs (irrespective of span), the Roof Razor® can be used in requirements for HVAC weight-loads within this weight bracket. At 2kg in weight, the Roof Razor ® is strong and durable for metal roofing systems and is recommended for use with the Permastop® and or Permatuff™ Building Blanket range
Key Features:
- Leading metal insulation spacer; engineered to allow full recovery of insulation between the safety wire mesh and metal deck cladding in typical commercial roof systems.
- Ideal solution to satisfy NCC, Section J Energy Efficiency requirements.
- Boasts an impressive national reputation built on ease and speed of installation.
- Seamless compatibility with all relevant insulation blankets and roof cladding profiles.
- Suitable for use on roofs with a pitch up to and including 30 degrees.
- Options for cyclonic regions.
- Wide and stable enough to walk and balance on – may be trafficked the same as a purlin.
- Supplied pre-loaded with screws for rapid installation.
- 1200mm length to match typical Permastop® Building Blanket width, allowing for a direct line of sight to the purlin.
- Incorporates an overlapping tab which specifies where to position the consecutive spacer.
- Cuts through insulation to give a direct connection to the purlin, ensuring that over time the bracket will not loosen as a result of vibration and movement.
- Australian made.